Skip to content

Gemmology — Specific Gravity Testing

Specific gravity testing

Use hydrostatic weighing and explore measurement error.

← Instruments

What this test observes

Specific gravity compares a material’s density with a reference, usually water in gemmological practice. Hydrostatic weighing uses an air reading and an immersed reading to estimate this relative density.

Underlying property: Physical properties.

Why the immersed reading is lower

Water pushes upwards on a submerged stone. This buoyant force equals the weight of the water displaced. The suspension therefore carries less load in water than in air.

SG = A / (A − W)

A is the stone’s mass reading in air; W is its apparent mass reading while freely suspended in water, with the support correctly tared. A − W corresponds to the displaced water. Both readings must use the same unit.

SG is relative density and has no unit. Density is mass divided by volume and may be stated in g/cm³. A stone resting on the vessel bottom does not give the suspended reading required by this method.

Parts and setup

  1. Check and level the balance. Prepare a clean, suitable loose stone and a thin suspension that does not touch the vessel.
  2. Tare the air-weighing support and record the stone’s air reading A.
  3. Support the water vessel independently of the balance pan. Immerse the empty suspension to its working depth and tare it.
  4. Place the stone in the immersed cage. Keep it fully covered by water, free of bubbles and clear of the vessel walls and bottom. Record W.
  5. Repeat the readings and calculate SG. Keep immersion depth and water conditions consistent; record temperature and the balance’s precision.

Explore the hydrostatic balance in 3D

Select each numbered component, then switch between weighing in air, taring the empty immersed cage and weighing the immersed stone. The water vessel is supported independently of the balance pan.

Preparing the 3D instrument…

Choose a part to inspect.

The balance display follows the readings in the observation lab below.

At the immersed step, the downward arrow represents gravity and the upward arrow represents buoyancy. Arrow sizes explain direction, not a measured force.

Make an observation

Observation lab

Weigh in air and water

Start with the support tared and no bubble. Compare the air and immersed readings, then add a bubble or remove the tare. The 3D balance display follows the selected weighing step and these readings.

Preparing the diagram…
Preparing the observation…

Hypothetical readings in grams using SG = A / (A − W). Tare and bubble offsets are illustrative. This is not a precision measurement or a named gemstone preset.

Interpretation and limitations

For this method, SG = A / (A − W). SG is a ratio and has no unit. A trapped bubble adds buoyancy, reducing the immersed reading and biasing the calculated SG downwards. Poor taring, surface tension, porous materials, mountings and small sample size can all compromise the result. Invalid reading pairs should be corrected rather than interpreted.

Check the measurement

Check your understanding

Answer each question before opening its explanation.

1. What does A − W represent in the weighing formula?

The apparent loss of weight on immersion, corresponding to the buoyancy for the stated method.

2. What happens if a trapped bubble lowers W?

A − W grows, so the calculated SG is too low.

3. Does SG carry units of g/cm³?

No. SG is a dimensionless relative density; density itself may be expressed in g/cm³.

4. Why support the water vessel independently?

The balance should measure the suspension’s load, not carry the vessel and water as well. Touching the cage to the vessel also compromises that separation.

5. Why tare the cage at its working depth?

The immersed support contributes to the balance reading. Taring it under the same conditions removes that contribution before the stone is added.